Sdc S6100 SERIES REVERSIBLE PANIC/FIRE EXIT Manual de usuario descargar pdf (Pagina 15)

P:\INSTALLATION INST\Mechanical Hardware\INST-S6800.vsd Rev - 12/10 Page 3

A. PREPARE DOOR

1. Mark centerline of device by

drawing a line across the door.

2. Mark a backset line and 4 thru

holes for device chassis shown

on the template provided.

3. Prepare the door cut-outs by

using the template provided.

Figure 1-2

4. Cut out the top edge and bottom edge of the door, then weld two 5mm thick mounting plates

on both edges for Top and Bottom Latch Assemblies (figure 1-2).

5. Drill holes and use a #10-24 tap on the mounting plates on the top and bottom of door.

The centerline of the

device must be 40"

above the finished

floor. Bottom Door

gap MUST be 1/4”.

2-7/16"

of Device

Mark backset from edge of door

INSIDE FACE OF DOOR

Drill holes and

cut-outs on the

Device side ONLY

of Device

”

See Trim Installation

Instructions for outside

face of door preparation.

Figure 1-1

1-3/4”

2-1/4”

7/8"

2-7/16”

1-19/32"

1-9/32"

1-5/32"

23/32"

1-11/16"

7/16"

7/8"

Inside Face

of Door

1-17/32"

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22 23

Comentarios a estos manuales

Sin comentarios

Sdc S6100 SERIES REVERSIBLE PANIC/FIRE EXIT Manual de usuario Pagina 15

Comentarios a estos manuales

Relacionado con productos y manuales para Para Casa Sdc S6100 SERIES REVERSIBLE PANIC/FIRE EXIT